Synergy is a unique technology for use with automatic, or floating, feeders
in any type pool. It is a self-contained system that gives you everything
you need to maintain amazingly clear, comfortable water, all in a single
box. And because of its effectiveness, there are only 2 products to
add once a week to keep your pool sparkling and algae-free.
STARTING
YOUR POOL ON SYNERGY
BALANCE
THE WATER,
TOTAL
ALKALINITY should be adjusted to 125-150 ppm.
To raise total alkalinity use OMNI
ALKALINITY INCREASER per label directions.
CALCIUM
HARDNESS should be adjusted to 200-275 ppm for
plaster pools and 175-225 ppm for painted, vinyl or fiberglass pools.
To raise calcium hardness use OMNI
CALCIUM HARDNESS INCREASER per label directions.
METALS
should
be absent in your pool water. If metal is present in the pool or in
your source water, treat the pool with OMNI
STAIN AND SCALE CONTROL per label directions.
STABILIZER
levels should be less than 200 ppm.
CLEAN
your
automatic feeder and remove all other chemicals from the skimmer and
feeder. Turn the automatic feeder to the lowest possible setting before
you start up on the Synergy System.
ADD
SYNERGY INITIATOR with
the pump and filter running at the rate of 5 lbs. for every 4,000 gallons
of pool water. Apply SYNERGY
INITIATOR by slowly pouring directly into the pool skinner.
Do not backwash the filter for 48 hours, and allow 4 to 8 hours of circulation
(pump running) after application.
SUPER-CHLORINATE
to
remove any chlorine demand from the water by adding OMNI
BREAKOUT 60 at a dosage rate of 1 lb. for every 10,000 gallons
of pool water. Test for free chlorine 24 hours after shocking. If your
pool water does not have a minimum of 2 ppm free chlorine, repeat the
super-chlorination procedure.
WEEKLY
ROUTINE MAINTENANCE
TEST
free-chlorine sanitizer and pH using your 4-WAY
TEST STRIPS. If necessary, adjust pH to 7.2 - 7.6. If sanitizer
level tests below 1 ppm, slightly open your feeder to maintain a 1.0
- 1.5 ppm sanitizer level.
ADD
SYNERGY TABS once
a week by carefully filling the feeder per the manufacturer's directions.
If the feeder is not a floating type, turn off the pump before opening
the feeder -- and stand to the side when removing the lid.
ADD
SYNERGY CLEAR at
the rate of 1 half container per 10,000 gallons of pool water once a
week. With the pump running, broadcast SYNERGY
CLEAR* into the deep end of the pool. Use a pool brush to
disperse any granules which may have settled to the bottom of the pool.
Swimming may resume 15 minutes after applying SYNERGY CLEAR*. |