 |
 Related Products
|
Green Treat
Yellow Treat Biquanide
Algae X
Algaecide 60 Ex. Strength
Black Treat
|
|
|
Algae Kill Ii(Copper Base)
by Omni
| | 1 PT. | $12.15 | Out Of Stock |
| | 1 QT. | $17.99 | Out Of Stock |
|
CONCENTRATED ALGAE KILL II is used for controlling algae in swimming pools. It is specifically formulated for green,blue-green (frequently called black or spot algae) and mustard colored algae growths. ALGAE KILL II may be used in pools treated with chlorine, bromine, or any other sanitization system except biguanides.
DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner inconsistent with its labeling. Read entire label and use strictly in accordance with precautionary statements and directions.
Ensure all pool equipment is working properly. Backwash the filter system following manufacturer's directions. Adjust pH to between 7.2-7.6.
DILUTION DIRECTIONS:
Always dilute product before addition to pool water. In a clean plastic container, dilute the required amount of this product in 3 to 4 gallons of pool or tap water. Stir and mix with a clean wooden or plastic utensil. With the pool pump and filter in operation, dispense the diluted solution equally around the inside edges of the pool.
POOLS WITH VISIBLE ALGAE: In chlorine treated pools, add stabilizer to establish a minimum level of 40-50 ppm to reduce the degradative effects of sunlight upon the chlorine residual. Check for metals and if present, add stain and scale inhibitor to prevent staining of pool surface due to metals. Add 1 pound of Breakout per 10,000 gallons of water to oxidize water soluble organic wastes. Allow to circulate one hour before addition of this product. When using other products as outlined in directions for this product, always follow directions on those products. Following Dilution Directions above, add 8 ounces of this product per 10,000 gallons of water. If necessary, the next day brush dead algae off pool surfaces so it can be filtered away. In extreme cases if algae still persist, repeat treatment after 2-4 days. Use of a stain and scale control and filter aid is recommended 2 days after final treatment to remove residual copper from pool water.
POOLS WITHOUT VISIBLE ALGAE GROWTH
Initial Treatment: Following DILUTION DIRECTIONS above, apply 4 ounces of this product per 10,000 gallons of water.
Maintenance Treatment: Following DILUTION DIRECTIONS above, apply 2 ounces of this product per 10,000 gallons of water every two weeks as a maintenance application.
NOTE: Shocking compounds should be pre-dissolved before addition when using this product.
|
|
|
|
|
|
|